The walls that had been installed needs to be protected (closed) with a layer of mortar species, so that the wall was more neat and beautiful. Specific areas of the bottom wall which is in contact with a waterproof plaster as high as ± 20 cm. Before starting with stucco work, first pieces of mortar, dust or other impurities, which stick to the walls need to be cleaned by spraying water on the wall.
Mix mortar used for plastering is 1 pc: 2 sand to the bottom wall (water-resistant) and 1 pc: 4 sand for plaster work on the middle and upper unrelated to water. At the corners of the wall defects often occur as a result of the hard object collision, mortar to plaster the angle must be made stronger than the other.
As for the reinforced concrete, before plastering begins, the concrete surface should be thick semen. It is intended that between the stucco and the concrete surface can be fused with the powerful.
Once the wall is attached to the top, begin coating the brick wall coverings. Coating is done with plastered to the wall. Outside wall or boundary plots usually only disawut (stucco without smoothed and without diaci). We recommend that when starting a job plastering the brick walls should be doused with water first so fast stucco on the wall. Once the entire wall plastered, let stand a few days so that the water level is rapidly lost.
Usually after the water content has evaporated entirely, stucco will look tiny cracks. The plaster work is usually done on the field at the top of the wall and foundation (trasram / semenram). Trasram job to prevent foot wall does not suck moisture (water) from the ground.
Adukannya is made watertight with eampuran 1 pc: 2 sand. Among the bottom to the top of the foundation wall, now many fitted with reinforced concrete beams (sloop) with a view to leveling the load received by the foundation building that also functions as trasram.