Jigger-Jolley manual tool can be directly used to form ceramic objects when catakan casts and profile has been provided, if casts and profile are not yet available it needs to make models and molds of plaster material and then create the profile, after the completion of a new form of ceramic objects.
The process of formation of ceramic objects form a large plate with a tool jigger- Jolley manually actuated by foot.
1 Prepare the clay in plastic and homogeneous conditions.
2 Make a clay slab using roll and wooden slats with a thickness and diameter corresponding to the mold plate.
3 Prepare jigger tool manually, place the plate on the holder mold and mold forming pairs profile or knife used. Adjust the position of the stop (bolt barrier) and the corresponding height profile fit the mold plate thickness made of ceramic objects.
4 Place the plastic clay that has diuli into the mold plate.
5. Press slab of clay by hand to stick to the mold plate.
6 Align and puree clay tablets using a wet sponge.
7 Rotate the mold jigger slowly, then lower the handle profile to eroded clay tablets. Clean the remains of clay attached to the profile.
8 Perform the formation of the plate with a jigger adjust the size of the stop (bolt. Barrier) to form plates according to size.
9 Raise the profile handle with a jigger then rotated, cut the excess clay lip plates using wire Butsir.
10 Play jigger and do erosion ketebal clay to achieve appropriate to its size or according to the stop (bolt barrier).
11. When finished, lift the mold plate carefully and place on a drying rack
12. Wind -aired until the clay becomes dry enough to be easily removed from the mold.
13. Remove the plate from the plaster mold after it is completely dry.
14. Dry the plate is to be ready at the cookies burn.
