1 Determine the line for the models to determine the parts of the plaster mold and define the hole foundry for pouring the slip clay. Do it right in order to avoid bearing on the time of printing.
2 Make the backing on the model animals using clay plastic according to the line for models that have been made. Grease the model with separation solution.
3 Close the model and backing using lenoleum to making a plaster mold First, determine the thickness plaster mold to be made (Approximately 6 cm).
4. Ikatlenoleum using rubber and put a wrench on the clay the basis that no plaster of paris is out.
5 Create the dough casts with size according to the thickness of the mold to be made.
6 Pour batter into gis mold models carefully and evenly on the entire surface models and wait to plaster hardens.
Open 7 lenoleum mold and clay backing of the model, make some holes for Key plaster mold then clean. Grease a cast on the parts of the mold using separator solution to each each plaster mold can removed / opened easily.
8 Attach the molding to lenoleum make a plaster mold side Other then spread with solution separator, belt lenoleum with rubber and give the torsion clay at the bottom of the order no plaster of paris which exit.
6 Pour batter into gis mold models carefully and evenly on the entire surface models and wait to plaster hardens.
Open 7 lenoleum mold and clay backing of the model, make some holes for Key plaster mold then clean. Grease a cast on the parts of the mold using separator solution to each each plaster mold can removed / opened easily.
8 Attach the molding to lenoleum make a plaster mold side Other then spread with solution separator, belt lenoleum with rubber and give the torsion clay at the bottom of the order no plaster of paris which exit.
9 Make plaster of paris and pour on the model carefully and evenly on the entire surface of the model, wait until the plaster mold becomes hard.
10 Open lenoleum plaster mold and then open it carefully.
11. Put the mold, then make use tapered plastic clay to make a plaster mold hole. Attach lenolium then make plaster of paris and pour into a mold to make a plaster mold next.
12. Open lenolium and mold then clean and dry in the sun to dry.