The connection with metal laced ways can be used to bind the ends of sabuk.Sambungan hooks (hinged joint) dibua by installing a number of kai at the ends of the belt. Dengansabuah pin end of the hook is connected. In the meantime, a series of belts and pulleys can be classified into:
1. Belt open
2. Belt cross
3. Belt quarter turn
4. Belt with pulleys fasteners
5. Belts compound
6. Belt terraced
7. Belt with pulleys release
8. Belt V.
Belt open (open belt drive)
Used to connect a parallel duaporos rotating in the same direction. Distance both large shaft axis, so sisikencang belt should be placed at the bottom
Figure 3.26 Open belt drive
Belt cross (cross or twist belt drive),
Known punter belt also used for two rounds sejajardengan shaft in opposite directions. It should be noted, that an intercourse belt belt abrasion akanmenimbulkan each other. To avoid shafts must memunyai jarmakasimum 20x wide belt, with speeds below 15 m / s
Belt quarter turn (quarter turn belt drive)
Used to pivot perpendicular and berputarpada a certain direction. If desired other direction needs to be mounted pulleys pegarah (guide pulley). To prevent the escape of belts, pulleys tangent field width must be greater or equal to or equal to 1.4 the width of the belt.
Figure 3:27 Belt quarter turn
Belt with pulleys fasteners
Used on a shaft parallel to the small contact angle.
Figure 3.28 with a pulley belt fasteners
Belt compound (compound belt drive)
Used to pass power from one shaft to poroslainnya through several pulleys
Figure 3:29 belt compound
Belt-rise,
Used if desired shaft speed changes were highlighted on waktuporos drive spins at a constant speed.
Belt with pulleys release,
Digunak if desired run or stop the drive pulley shaft mesintanpa influence. Puli terpasak on a machine called a pulley fast, free and pulleys yangberputar called loose pulley