" /> Main Parameters Hydraulic Reservoir - TN Mesin
Home > English > Main Parameters Hydraulic Reservoir

Main Parameters Hydraulic Reservoir

The ideal size of the reservoir is two to three times the maximum pump flow. If the cylinder is great, especially the kind of telescoping used, then the capacity of the reservoir should be sufficient so that there is no air in the range of the pump when all cylinders extended. Separator plates must separate suction pumps and hoses to cool the system inverting oil, allowing air to rise and contaminants out. The size of separator plates about 2/3 of the total height of the reservoir. The bottom should be cut larger than the size of the suction pump, so that it can prevent the unequal size of the oil in the tank.
image

Suction strainer must have already installed and should be quickly cleaned. Clutch heavy equipment to be used for inverting or hose connection waster stream. Nipples inverting the tank must sweep near the bottom of the reservoir, which is below the oil gauge. Nipple should be cut at an angle of 45 degrees and faced away from the suction end of the pump reservoir. This method tends to dissipate heat and transfer the oil to the circulation patterns to ensure that the suction accept and does not interfere with the oil cooler.

Cleaning should be done so that there is a spray plate inside the reservoir. Then scale welding and beam, the characteristics of the steel are susceptible to heat must be removed. Painting is recommended, using petroleum-based fluids, a layer of non-bleeding. No special coating for non-petroleum-based fluid. Thin bulkhead shall be used in the filler opening to prevent the entry of foreign objects, this opening must have adequate stock for tightening.

Systems with open type reservoir must have sucker mikronik already installed. Pressurized system must use a pressure relief valve to limit the reservoir and diperalati that filtered air at the time of sucking atsmophir. If there is a positive air filling of the air system on the vehicle, then the water trap to catch the humidity should be included. Traps must be available quickly to penyervisan every day.

Measuring tools (preferably) or dipstick is necessary to check the size of the oil. Inverting filter hose placement inside the resevoir difficult because it is more feasible filter installed outside the reservoir. All applications, especially in the pressurized system, must have five psi bypass check to prevent rupture of the filter seal, canned and elements. Make sure that the positive oil in the pump head, will help avoid damage to the pump.

Reservoir pressurized oil creates a positive head. Noisy pump might be due to cavitation and foam. Oil milky and murky is an indication of the presence of air and water on the suction side of the pump. If the oil is clean but the pump is still noisy, then it may cause is due to cavitation. Try and avoid in order to keep the vacuum pump. Suction flow must not exceed four feet per second, therefore, consider installing the short and long suction hose. During a heated pump, avoid high engine speeds, because of the cold and thick oil which can cause cavitation.