Plain wall surfaces may create the impression of saturating. Applications may also be less color makes it looks attractive. So that the wall is more interesting, it can be done with sawutan stucco, stucco so the results will form the texture. Results of stucco with sawutan can make the walls more colorful, especially if exposed beams, there are gradations of light and dark that can make the walls so dramatic.
That need to be considered in the stucco wall with sawutan is texture or fine sand bumps across the surface of the wall not to hurt the body, especially if the sand were used rather rough. This can be minimized using the right paint and the right menyawut techniques, so that the surface is rough and sharp stucco can be reduced. Disawut wall surface using a small hole sieve so that the texture that appears not too prominent.
This will make the skin friction with the wall is not too dangerous. Materials and tools used in the stucco wall with sawutan is;
1 Paint emulsions, coarse sand, white cement
2 chicken wire or cloth
3 Roskam, cement spoon, gloves
1 Determine the area of the wall that will be given to sawutan plaster, plaster should be used to this wall. Average stucco sawutan will get better results.
2 Prepare shredded tools, namely chicken wire that has been given a frame of wood or fabric (choose one). The tools selected will affect the texture formed.
3 sand to be used should be sifted clean of gravel,
4 Create-sand mortar with a ratio of 1: 3.
5. Apply mortar to the walls that have been plastered earlier.
6 If using chicken wire: throw it out loud with a spoon to mix the cement to break through the wire. Digesters thrown from a distance of about 30cm.
7 If using cloth: ramming quite attached to the wall by using Roskam after the scrub with the direction of play.
8 Especially for engineering fabric, wait until the results sawutan half dry before brushing the wall with a circular motion using a cloth that has been given Roskam.
9 Let stand until dry. Then paint with emulsion paint according to taste.
