English

Manual and Automatic Manual control is done by human control that acts as operator, while control is automatically performed by the control of machines / equipment that works automatically and operation under the supervision of a human. Examples of control manually are found in everyday life such as the regulation of radio, television, light settings screen, setting the water flow ...

In the selection and use of a sensor, the necessary considerations, so as expected. Considerations include: 1. Identification of the actual signal. This stage includes the nominal value and the sensor measurement range, the physical condition of the environment where the measurement is made, the required measurement speed, and others. 2. Identify the required output signal. Most of the output ...

Overall the survey shows that the application of electronics is happening in the industry suggests that the development of digital techniques happen very quickly. There are many reasons why this could happen, but only two reasons in this section are important. One is the reduction of the uncertainty, related information encoded digitally compared to the analog information. For the record ...

Open circuit means is not connected with any other circuit. Imposition happens when we connect to it with a load or integrated circuits are added to the output earlier (see Figure 2.23 (b)) and the output voltage before being dropped off several volts if debandingkan with an open circuit before, where V y2 <V y1. Different loading will result in ...

In the electronic control system, the controller used is a unit consisting of electronic components. Here is a series of electronic unit that is integrated from many electronics components, namely resistors, capacitors, inductors, diodes, transistors, op-amp, IC and many other electronic components. The electronics unit, could be a series of simple or complex circuits. One of the electronic components that ...

To eliminate unwanted noise signal of measurement, it is often necessary to continue the use of the circuit or eliminate the signals in a specific frequency region. The circuit is called a filter. A simple filter can be made of a resistor and a capacitor. This circuit could form the filter circuit Lowpass and Highpass filter. Filter Lowpass Lowpass can ...