" /> TN Mesin | Page 3 of 34 |

Release And Fitting Components

PAST The method of disposal and installation of components on heavy machinery in the early days is still very simple. At that time the special equipment used or the standard procedure is still very little. “The purpose of removing and installing components is to remove components as quickly as possible, repair them as needed and reinstall them for use again.” ...

Read More »

Peralatan Kerja Perawatan dan Perbaikan

Ketika melakukan perawatan diperlukan peralatan untuk melakukannya. Tanpa mengetahui peralatan yang tepat untuk melakukan suatu pekerjaan dapat menyebabkan kerusakan yang tidak dikehendaki. Oleh karena itu pemahaman tentang alat menjadi suatu hal yang sangat penting dalam pekerjaan perawatan dan perbaikan. Kecelakaan kerja yang disebabkan karena kesalahan penggunaan alat dapat membahayakan diri pekerja, rekan kerja, barang dan atau alat itu sendiri. Materi ...

Read More »

Procedure Lock Out

Lock out circuit is a standard procedure that is used to disconnect the electrical power supply to the equipment is under maintenance or repair. When a technician / mechanic refrigeration / air system will work at an electrical equipment before working then he must first disconnect the power source that led to the equipment. And to prevent it from any ...

Read More »

Impact Shock Electric Current

Here is an impact of electric shock as seen from the magnitude of electric current flowing in the human body. Electrical current of 1 miliamper create the sensation of someone, a current of 20 miliamper memungkinkanseseorang can not move, a current of 100 miliamper cause the ventricuar fibrillation (heart pounding), and the current is greater than or equal to 200 ...

Read More »

The Sting of Electric Current

Electric shock and burning body is the general risks faced by personnel working in the field of refrigeration and ventilation. Not possible to do the installation work or troubleshooting refrgerasi and HVAC equipment without connecting the equipment to a power source. It is already the responsibility of the technician / mechanic refrigeration and HVAC think of safe work procedures when ...

Read More »

Peralatan Sliding Handle dan Kunci Momen

Sliding Handle digunakan untuk mengendorkan baut/mur yang memiliki momen pengencangannya cukup tinggi karena dapat dioperasikan dengan kedua tangan. Juga dapat untuk membantu melepaskan atau memasang. Pengancangan baut/mur ada prosedurnya tersendiri menggunakan kunci khusus yaitu dengan kunci momen (Torque Wrench). Gambar Kunci Momen: 1. AdjustableTorque Wrench 2. Non-adjustable Torque Wrench Kunci momen ada yang bisa disetel kekencangannya dan ada yang tidak ...

Read More »