English

Some of which we will discuss are the tools that convert electrical energy into other forms of energy. This is important given the amount of electricity consumption in the unit during operation, depending on how many devices are used, for example when the unit works at night with all the lights on and the air conditioner also works with the ...

As shown in Figure below, transistors have two junctions, one between the emitter and the base, called the Base Diodes – emitter, and the other between the collector and the base, called the Base Diodes – Collector. Since each diode has 2 possible bias, the bias Manu (forward biased) and bias backwards (reverse biased), the transistor has 4 (four) the ...

In general, the power supply is always equipped with a regulator tegangan.Tujuan installation of the power supply voltage regulator is to stabilize the output voltage when the input voltage changes occur on the power supply. Another function of the voltage regulator is to protect against the occurrence of short circuit in the load. One method that can generate a stable ...

The success of the installation of the control panel manufacture electric motors basically depends on how to understand thoroughly (carefully) according to specifications. The design of the equipment, circuit diagrams, component selection and installation of the motor control can vary according to the complexity of the system and component selection of the service providers. Besides this, for the simple system ...

KWH Meter is used to record the amount of electrical energy used by a power load be it resistive, inductive, capacitive. Everything will be recorded by the KWH Meter tool. Based on how it works (design) KWH Meter is divided into two parts, namely: 1. KWH meter with motor prinsif, 2. KWH meter with static meter. Static meters are used ...

Magnets or magnetic contactor switch is a switch that works by magnetism, meaning that the switch can work if there is a magnetic force. Magnet serves as towing and release contacts. A contactor must be able to drain and disconnect the electric current in normal circumstances. Electric current flowing normally is an electric current flowing during the termination does not ...