Lepaskan terlebih dahulu pompa dari peralatan yang akan diperbaiki. Gunakan prosedur pembongkaran pompa dari pembuatnya. Gunakan peralatan yang tepat dan patuhi prosedur keselamatan seperti yang ditegaskan oleh pembuatnya. Gambar 3.47 Pasang pompa pada ragum atau meja untuk pembongkaran (bagian poros berada di bawah) (Gambar 3.47 kiri). Dengan peralatan penggores dari logam tajam, pensil atau magic marker (spidol khusus), buatlah garis/tanda ...

The reservoir should accommodate a liquid free from air bubbles into the suction tube. All hoses enter and leave the tank below the liquid level. The drain hose must have at least 3 feet of flexible hose larger than the tap that goes into the frame of the pump or motor. Pipes shall be isolated from structures made of rubber, ...

Hygiene is a key way of ensuring the life span, whether for a new unit or an improved unit. Cleaning of parts by using solvent and dried in the air is considered adequate, assuming that the liquid used is clean. Meanwhile, for equipment that requires precision, its internal mechanism must be free of chemicals and particulate contamination. SPECIAL ATTENTION AND ...

Ukuran ideal reservoir adalah dua sampai tiga kali aliran pompa maksimum. Apabila silinder besar, khususnya jenis telescoping yang digunakan, maka kapasitas reservoir harus cukup supaya tidak ada kisaran udara dalam pompa pada saat semua silinder diperpanjang. Pelat pemisah harus memisahkan isapan pompa dan selang pembalik sistem untuk mendinginkan oli, membiarkan udara naik dan bahan kontaminasi keluar. Ukuran pelat pemisah kira ...

Starting with: Attach body retaining pin by raising the dump body . Then enter the body retaining pin in place, ie on the left and right side of the machine. Figure 3.14 Pin holder dump body WARNING ! At the operating temperature, the hydraulic tank is hot and under pressure. Hot oil can cause burns. To prevent possible injury, remove ...

a. Moment of Inertia Against Horizontal axis (XX) Moment of inertia of the cross section to a line that is the number of cross-sectional area (element) multiplied by the square of the smallest normal distance to the EAM, or cross-sectional area multiplied by the square of the distance. If the cross-sectional area is the smallest elements DA1, DA2, dA3 …. ...