PAST The method of disposal and installation of components on heavy machinery in the early days is still very simple. At that time the special equipment used or the standard procedure is still very little. “The purpose of removing and installing components is to remove components as quickly as possible, repair them as needed and reinstall them for use again.” ...

Pada saat memilih cairan hidrolik yang benar, poin-poin dibawah ini harus dipertimbangkan: kesesuaian dengan sistem, persyaratan temperatur, konstrusksi komponen, tekanan saat pengoperasian, dan persyaratan kekentalan. Konsultasikan dengan suplier tentang cairan dan konsultasi ke pabrik pembuat untuk mendapatkan bantuan dalam menentukan cairan yang sesuai dengan pekerjaan. Ada cairan yang tidak cocok digunakan pada sistem hidrolik modern dan cairan yang salah akan ...

The ideal size of the reservoir is two to three times the maximum pump flow. If the cylinder is great, especially the kind of telescoping used, then the capacity of the reservoir should be sufficient so that there is no air in the range of the pump when all cylinders extended. Separator plates must separate suction pumps and hoses to ...

At the time of selecting the correct hydraulic fluid, the following points should be considered: conformity with the system, temperature requirements, konstrusksi components, pressure during operation, and viscosity requirements. Consult with the supplier of the fluids and consult the manufacturer for assistance in determining the appropriate liquid with the job. There is a fluid suitable for use in modern hydraulic ...

This valve serves to control / controlling the size of the hydraulic fluid flow .It is assumed that the magnitude of the flow is the amount of hydraulic fluid flowing volume will affect the speed of movement of the actuator. Various flow control: a. Fix flow control passageways size of the hole is fixed (not adjustable) b. Adjustable flow control ...

Dimulai dengan: Pasanglah body retaining pin dengan cara menaikkan dump body. Kemudian masukkan body retaining pin pada tempatnya, yaitu pada sisi kiri dan kanan mesin. Gambar 3.14 Pin penahan dump body PERINGATAN ! Pada suhu operasi, tangki hidrolik bersifat panas dan di bawah tekanan. Oli yang panas dapat menyebabkan luka bakar. Untuk mencegah kemungkinan terjadinya cedera, lepaskanlah tekanan dalam sistem ...