" /> TN Elektro - Page 5 of 66 -

FLIP-FLOP Basic Material

Is a circuit that can store binary state (as long as there is power in the circuit) until there is a change in the input signal flip-flop base circuit. Flip-flops can be created from the following two NAND or NOR gates: A. RS Flip-Flop With Clock By adding several gates to the base circuit input section, they can only respond ...

Read More »

Electrical Measurements Phase Driving System

Energimeter an instrument that is most widely used to measure the electric energy consumption in a domestic or commercial electrical installations. Electrical energy is measured in units of kilo watt-hours (kWh) with energimeter. Therefore energimeter also commonly referred to as kWh-meter. Driving the system is composed of two electromagnetic energimeter of laminated silicon steel, magnetic shunt and series magnets as ...

Read More »

Three-Phase Measurement With Wattmeter

Three-Phase Power Measurement with One Wattmeter Three-phase power measurement with one wattmeter can only be applied when the three-phase load in balance (symmetrical). Three-phase load is said to be balanced when the current flowing in each phase the same, thus the power carried by each of the same phase. So that the total power is three times the power of ...

Read More »

Electrical Energy System Three Phases

In Figure 7.16 is shown the construction of three-phase kWh-meter and wiring. KWh-meter three-phase having ten terminals. Torque moving the disk rotational torque is the sum of each phase. Furthermore, the swivel moving mechanical disc recorder, and calibrated to show the total energy used by a network of three-phase systems. For the purposes of determining the energy consumption that has ...

Read More »

Op-Amp Characteristics

In designing level meter signals, temperature control hysteresis, oscillators, signal generators, audio amplifiers, mic boosters, active filters such as bass tape filters, mixers, signal converters, integrators, differentiators, comparators and a host of other applications, -back component data called op-amp. Components of analog electronics in the packaging of ICs (integrated circuits) is indeed a versatile component and used in many applications ...

Read More »

Unidirectional Voltage Measurements

Have resistance meter gauge voltmeter voltage Rm. Prisoners dalammeter also show sensitivity meter, called Ifsd (full scale deflection) the current needed to move the needle on the meter full scale. To raise the limit measure voltmeterharus mounted custody series of RV. Figure 6:29 Basic circuit Voltmeter Equation prisoners RV meter series: Figure 6:30 shows the basic circuit of alternating current ...

Read More »