Prinsip Dasar Hidrolik

After studying the possibilities of damage that occurs in the hose will be discussed later under the hose fitting. Of course that would be fitted hose meets the requirements of various factors in a hydraulic system. There are at least six rules in the installation of hydraulic hose. 1. Voltage hose must be avoided. Although the ends of the hose ...

Overview on the 3102 series of images below shows the working principle of state control entry. Figure 3.94 Conditions controlling entry If the cylinder is controlled conditions at the time the forward motion diagram as above, the movement of the fluid flow is as follows: Fluid coming from the tank (reservoir) will be pumped through (B), by the first fluid ...

Leaks are the most common damage to hose connector. Usually leaks are a result of screw peeled, damaged O-ring, or sealing is not suitable. In many ways, the damage resulting from improper assembly connecting the ends of the pipe. Initial damage can be caused by hardening (tightening) that exceeds the swivel nut threaded pipe while letting loose. Another possibility of ...

Figure 3.96 meter-out flow control conditions controlling the flow out When the desired amount of fluid that comes out is set then the sequence is called a meter out. Actually, the same circuit with the meter in conditions, only difference lies in the position of the exit of the cylinder. At the feet in, flow control valve is placed before ...

Construction The inside: black synthetic rubber. Upholstery: Two woven fiber. Cover: oil resistant synthetic wire and scratches, The inside: black synthetic rubber oil resistant. Upholstery: One braid steel wire that has high tensile strength. Cover: Black synthetic rubber resistant to scratches and oil Usage Channels of hydraulic oil, fuel, anti-freeze, or water channels Temperature limit: -40 ° F to + ...

If the hose is damaged earlier, the possibilities of damage that occurs is: crack, tear (split), small leaks, improper hose length, friction, heat, twist, selecting the wrong hose, fitting one, or who is not laying appropriate. Crack or tear in the outer layer (cover) hose is common and does not always mean a hose destroyed. The depth of damage is ...