" /> TN Mesin | Page 34 of 34 |

Alat Obeng

Obeng dalam satuan set dalam ukuran dan bentuk penggerak yang berbeda, panjag, pendek, sangat pendek (buntung). Obeng terdiri dari batang yang terbuat dari baja keras berkualitas tinggi dengan satu mata pada satu ujungnya dan gagang terbuat dari plastik/kayu yang dicetak pada batangnya. Obeng digunakan untuk melepas/memasang sekrup dari komponen-komponen kendaraan bermotor seperti pada; lampu kepala, pelindung radiator, dan untuk melepas ...

Read More »

Disposal and Installation Process

In outline, before removing and installing the components, it must first observe the following: 1. Type / type of machine (component) 2. Other components installed on the machine 3. Supplies of equipment and materials 4. Safe work area 5. Purpose of manual book Careful observation can actually help smooth your work, and otherwise carelessness and observation that will surely trouble ...

Read More »

Penanganan Kecelakaan Di Lingkungan Kerja

a. Patah Tulang Bila penderita mengalami patah tulang atau diduga mengalami patah tulang, maka usahakan penderita jangan banyak bergerak. Balutlah bagian yang patah atau diduga patah dengan bidai (splint). Untuk lengan yang patah cukup dipakai satu papan bidai, jika kaki yang mengalami patah diperlukan dua atau tiga papan bidai. Sebagai pembalut dapat digunakan pita, kain atau tali yang lunak. Balutlah ...

Read More »

Hydraulic Reservoir Criteria

The reservoir should accommodate a liquid free from air bubbles into the suction tube. All hoses enter and leave the tank below the liquid level. The drain hose must have at least 3 feet of flexible hose larger than the tap that goes into the frame of the pump or motor. Pipes shall be isolated from structures made of rubber, ...

Read More »

Maintenance of Hydraulic Cylinders

As described in the previous chapter, the hydraulic cylinder construction is very strong, to know the disturbance causing the cylinder damage is located on the seals and pegs. Basically there are 2 (two) causes of damage that is in the leak and outside leaks. a. External leak : if the leaf end cap is leaky, it should be tightened fastening ...

Read More »

Component Release Planning

When newly installed components are problematic or damaged, the causes are often sourced from the discharge stage during the repair process. There are two main causes: 1. Urgent repairs In hasty repairs that heavy equipment can be reused immediately, the source of the damage is usually unrecognized and resolved. 2. Ease of repair Sometimes, ease of component replacement can slow ...

Read More »