English

PAST The method of disposal and installation of components on heavy machinery in the early days is still very simple. At that time the special equipment used or the standard procedure is still very little. “The purpose of removing and installing components is to remove components as quickly as possible, repair them as needed and reinstall them for use again.” ...

The ideal size of the reservoir is two to three times the maximum pump flow. If the cylinder is great, especially the kind of telescoping used, then the capacity of the reservoir should be sufficient so that there is no air in the range of the pump when all cylinders extended. Separator plates must separate suction pumps and hoses to ...

At the time of selecting the correct hydraulic fluid, the following points should be considered: conformity with the system, temperature requirements, konstrusksi components, pressure during operation, and viscosity requirements. Consult with the supplier of the fluids and consult the manufacturer for assistance in determining the appropriate liquid with the job. There is a fluid suitable for use in modern hydraulic ...

This valve serves to control / controlling the size of the hydraulic fluid flow .It is assumed that the magnitude of the flow is the amount of hydraulic fluid flowing volume will affect the speed of movement of the actuator. Various flow control: a. Fix flow control passageways size of the hole is fixed (not adjustable) b. Adjustable flow control ...

Pneumatic comes from the Greek “pneuma” which means blowing or blowing. So pneumatic means filled with either air or compressed air driven. Pneumatic definition is a branch of physics that studies the phenomenon of compressed air so that the pressure will produce a force as the cause of motion or actuation on the actuator. Pneumatics in industrial automation is moving ...

Spool valve, pump and motor shaft are allowed to dry can be affected by rust and corrosion on the climatic conditions are unfavorable. If the vehicle is stored outside, it is recommended to coat all exposed surfaces by using grease protective paint if not used immediately. A crucial step in the care of the vehicle using hydraulic equipment is to ...